蜜桃久久精品成人无码AV_国产成A人片在线观看视频下载_国内精品久久久久精品爽爽_国产乱子伦

What are the processing points of PBT engineering plastics

2019-08-09 1206

Monotonic treatment: this kind of data is easy to hydrolyze under high temperature, so monotonic treatment before processing is very important. It is suggested that the monotonic condition in air is 120 ℃, 6-8 hours, maybe 150 ℃, 2-4 hours. It is necessary that the humidity be less than 0.03%. If the hygroscopic monotone is used, the recommended condition is 150 ℃ for 2.5 hours.

2. Melting temperature: 225-275 ℃, recommended temperature: 250 ℃.

Mold temperature: 40-60 ℃ for unreinforced type. The cooling cavity of the mold should be well designed to reduce the twists and turns of the plastic parts. The loss of heat must be fast and uniform. It is recommended that the diameter of the mold cooling cavity is 12mm.

3 injection pressure: medium (up to 1500bar).

4 injection speed: the injection speed should be as fast as possible (because PBT coagulates quickly).

5 runner and gate: Circular runner is recommended to increase pressure transmission (empirical formula: runner diameter = plastic thickness +1.5mm). Be able to use various types of gates. Warm runner can also be used, but attention should be paid to avoid data leakage and degradation. The gate diameter should be between 0.8-1.0*t, where t is the thickness of the plastic part. For submerged gates, a minimum diameter of 0.75mm is recommended.

Article source: PBT engineering plastics http://www.fcyou.com/


主站蜘蛛池模板: 鄂托克旗| 崇仁县| 林周县| 荔波县| 泌阳县| 台中县| 宁蒗| 剑河县| 安平县| 吉林省| 宝兴县| 岳阳县| 衡山县| 英山县| 红安县| 剑河县| 华蓥市| 安仁县| 太保市| 富顺县| 蓬溪县| 聂荣县| 黄大仙区| 碌曲县| 杭锦旗| 琼中| 科技| 晴隆县| 左贡县| 呼玛县| 张家口市| 海南省| 泰顺县| 罗江县| 克拉玛依市| 保山市| 武宣县| 共和县| 广宗县| 山西省| 高清|